Edgemere Repointing
Brick Pointing in Edgemere, Queens
Failing mortar cut out and replaced on Edgemere brick buildings, chimneys and walls that take salt air and storm driven rain off the water.
- Facades, chimneys and garden walls
- Mortar cut out and repointed by hand
- Free visit and written price
Where Does Brick Pointing Fit in Edgemere?
Edgemere is not a neighborhood of long brick row house blocks, so pointing here focuses on the brick that does exist: apartment complexes and NYCHA buildings, some brick faced homes, chimneys and low garden or yard walls. Many houses are frame, so we say plainly when a job does not apply.
If your home has brick on the front, a brick chimney or a brick planter wall, the mortar joints are what keep water out. Salt air and wind driven rain from the ocean and Jamaica Bay attack those joints faster than in inland Queens.
Apartment buildings with brick faces have far more joint length to maintain, and the height brings scaffold and access into the plan.
A quick test is to look at the wall from an angle in low sun. Shadows that show deep, empty joints tell you the mortar has receded past the point where a surface patch will hold.
- Crumbling, recessed joints
- Salt stains on brick faces
- Loose bricks on chimneys
- Cracks on windward walls
- Damaged parapet copings
- Failing garden wall caps
Mortar Falling Out in Edgemere?
Photograph the wall or chimney and send it over. We can judge how deep the decay runs.
What Does Failing Mortar Look Like?
Look for joints that are recessed, crumbly or gone, hairline cracks that follow the mortar lines, white salt deposits on the brick and bricks that wiggle when pressed. Any of these lets water into the wall, where it can freeze in winter and push the wall apart.
Coastal wind pushes rain sideways into vertical joints, so the windward side of a building often fails first. A chimney, exposed on all four sides, can lose joints fast.
Small cracks are worth fixing early. Repointing a section now costs far less than rebuilding a loose wall later.
How Do We Repoint Brick in Edgemere?
We cut out the old mortar to a proper depth, clean the joints, wet the brick and pack in new mortar in layers. Then we tool the joint to a consistent profile. The mortar mix has to suit the brick, since a mix that is too hard can crack the brick edges.
On a home chimney or a small wall, the work can be done in a few days. Larger buildings take longer and may need scaffold or a lift. We plan access with the owner or manager before pricing.
We keep the site tidy, protect windows and doors and sweep up the mortar dust each day.
Fresh mortar is protected from direct sun and wind while it sets. On the peninsula the breeze is constant, so we plan the work to keep the joints from drying too fast.
Do Edgemere Buildings Need Facade Inspections?
Local Law 11, the Facade Inspection and Safety Program, requires buildings taller than six stories to have facades inspected every five years. Some apartment buildings here may be that tall. Confirm with the owner's filing professional and the city whether a specific building falls under the rule.
If an inspection report calls for repairs, brick pointing is often part of them. We work from the report and coordinate with the engineer or architect who filed it.
Smaller homes are not covered by that program, but the same mortar decay applies to them.
What Affects Brick Pointing Cost in Edgemere?
The wall area, the height, whether scaffold or a lift is needed, how deep the old mortar has decayed and how well the new mortar must match all affect the price. The price arrives in writing once we have seen the wall, and we do not guess over the phone.
A chimney takes access work and careful handling at the roof line. A garden wall at ground level is simple by comparison. A broad facade brings scaffolding costs and more days on site.
Permits depend on the work. Scaffold on a public sidewalk or structural repairs can involve city permits, and we tell you early what we expect.
Should Mortar Repair Wait for Warm Weather?
Repointing needs mortar to cure without freezing, so late spring through early fall is the easiest season. Emergency repairs, such as a loose chimney course, can be made sooner, and we will tell you what to do while you wait.
Planning ahead helps because a good crew books up. If you see damage in winter, call for a visit so the job is ready when the weather turns.
Why Edgemere Owners Hire Us for Pointing
Mortar matched to the brick
We choose a mix that suits the wall and does not damage the brick.
25+ years of NYC masonry
Our crews know how city brick ages in wind, salt and freeze and thaw.
Licensed and insured
Every crew we send is covered for injury and workers compensation.
Nearby
Brick Pointing Near Edgemere
We repoint brick in the Rockaway neighborhoods around Edgemere.
FAQ
Edgemere Brick Pointing Questions
The terms overlap. Pointing means replacing failed mortar in the joints. Tuckpointing usually adds a thin contrasting line for looks. We explain which you need at the visit.
Expect a few days for a chimney or a short wall. A larger facade takes longer and depends on scaffold and weather. We give a time estimate in the written price.
Salt and wind wear any exposed material over time. Correct mortar and proper tooling slow that down a great deal.
Small jobs on private property often do not, but scaffold on the sidewalk and structural work can. Confirm current rules with the city.
Yes. Call (718) 468-8803 to set a free visit and get a written price.
Free on site estimate
Repoint Your Edgemere Brickwork
One visit, one written price, and joints that keep water out.
Contact
Request Your Pointing Quote
Tell us what brick you have and where the joints are failing. Photos of the wall help a lot.
- Call us(718) 468-8803
- HoursMon to Sat, 9:00 AM to 6:00 PM
- Free on site estimate with a written price
- Licensed and insured, 25+ years in business
- We handle DOT sidewalk permits
- Serving Manhattan, Brooklyn, Queens and the Bronx
Get Your Free Estimate
Takes about a minute. No cost and no obligation.