Flushing Concrete Contractor
Concrete Replacement in Flushing
Cracked yard slabs, patios, walkways and garage floors torn out and repoured at Flushing homes and small buildings.
- Yards, patios, walkways and slabs
- Old concrete hauled away
- Written price after a free visit
Which Flushing Concrete Is Most Often Replaced?
Back and side yard slabs, patios, front walkways, garage floors and the paved strips beside detached homes come up most. East and north of downtown, many houses have driveways, rear patios and side paths that were poured decades ago and have cracked.
Flushing has detached one and two family homes with yards, and dense apartment buildings and co ops with courtyards and service paths. The work on each is different, but the causes are the same: water, age and weak bases.
Trees matter too. The residential blocks have good tree cover, and roots push up slabs close to a trunk.
If your slab has lifted near a tree, tell us. We work out whether the roots are yours to cut or belong to a city tree.
- Slabs cracked in every direction
- Patios tilting toward the house
- Roots lifting concrete near trees
- Flaking, crumbling surfaces
- Sunken garage floor slabs
- Broken side paths between houses
Old Slab Cracking in Your Flushing Yard?
Send a picture and a rough size of the area. We will plan the pour.
How Do We Replace Concrete at a Flushing Home?
We break out the old slab, haul it off, regrade and compact the base and set forms to a slope that drains. Then we pour, finish and protect the new concrete as it cures. The work on a yard takes days, plus curing time.
Most lots have limited access, so equipment and material often go through a side gate. We plan the route at the visit and protect planting and fences where we can.
If part of the slab meets the public sidewalk, the work can follow one to two weeks with the DOT permit included.
When Is Replacement Better Than Patching?
Replace when cracks run in several directions, slabs rock or sound hollow, the surface flakes away or the pitch sends water toward the house. Patch a slab that is sound with one hairline crack. We will say plainly which of the two applies to your slab.
A patch over a failing base only delays the work. The water that got under the slab once will get under it again.
We show you the slab at the visit and mark the parts that should come out.
A quick test is to tap the slab with a hammer or a steel bar. A dull, hollow sound means the concrete has lost its base and the slab is riding on air.
Do Permits Apply to Concrete Work in Flushing?
A job kept fully on your own lot does not need the DOT sidewalk permit, while sections reaching the public sidewalk do generally need one. Retaining walls, curb cuts and structural work can involve the Department of Buildings.
We file the DOT permit on jobs that need it and tell you early if we expect DOB involvement. Rules change, so ask the city about your address as well.
Our page on sidewalk violations and how to clear them covers what DOT can cite.
What Drives Concrete Replacement Cost in Flushing?
Price follows area, demolition and hauling, base work, reinforcement, drainage changes and access. We measure on site and write the price, rather than guess over the phone, because every yard is different.
A slab that can be reached from the street costs less labor than one behind a house. A yard that needs regrading costs more than a simple swap.
Ask us to list each part. That makes it easy to compare with another contractor.
Nothing is hidden in the scope. Demolition, hauling, base, concrete, finish and any drainage work each get their own line.
Can You Add Drainage While You Replace the Slab?
Yes, and it is often the smartest time. With the old slab gone, we can regrade, add a trench drain where a patio meets a wall or extend downspouts away from the house. We only suggest what helps.
Low yards near the Flushing River can hold water after storms, and inland blocks can get sewer backups in heavy rain. A properly sloped slab helps move surface water away from the building.
What Should You Know About Concrete and Winter in Flushing?
Concrete can be poured in cold weather with protection, but hard freezes and heavy rain complicate the curing. We plan the pour for a suitable stretch and cover fresh work. Salt and ice melt attack young concrete, so go easy on it in the first winter.
Sweep sand and slush off new slabs instead of leaving them. A clean slab dries and ages better.
Concrete at the Sidewalk Named in a Notice?
We fix the sidewalk piece and keep the paperwork for you. Read our guide on what DOT lists in a sidewalk notice.
Why Flushing Owners Call Us for Concrete
A solid base first
We do not pour over a failing base.
Permit handled
We file with DOT when work reaches the sidewalk.
Licensed and insured
Construction, injury and workers compensation insurance.
Nearby
Concrete Replacement Near Flushing
We pour concrete in neighborhoods around Flushing.
FAQ
Flushing Concrete Questions
A typical yard job takes a few days on site plus curing. Jobs with a permit follow one to two weeks.
Yes. We keep roots you may not cut in mind and work around them. City tree roots need Parks approval.
Yes. Removal and hauling is part of the scope unless we agree otherwise in writing.
Yes. One scope and one schedule often cost less than two jobs.
Yes. Call (718) 468-8803 for a free visit.
Free on site estimate
Pour a New Slab in Flushing
Free visit, written price and a clear schedule.
Contact
Get Your Flushing Concrete Quote
List what has to go and how a crew would get to it. Photos help.
- Call us(718) 468-8803
- HoursMon to Sat, 9:00 AM to 6:00 PM
- Free on site estimate with a written price
- Licensed and insured, 25+ years in business
- We handle DOT sidewalk permits
- Serving Manhattan, Brooklyn, Queens and the Bronx
Get Your Free Estimate
Takes about a minute. No cost and no obligation.